|
|
|
|
Program Check codes indicate protocol or data stream errors detected by the 3270 emulation program. They appear on the 3270 status line as
PROGnnnmessages, where
nnnis defined as follows:
| Number | Description |
Invalid command received or invalid alias for SFE, MF, or SA | |
Out of range address for SEA, RA, or EUA order MF order addressed non-field attribute location |
|
Data stream data after Rd, Rd Mod, EAU command Invalid parameter following SFE, MF, SA, GE, or RA order | |
| Data stream terminated before end of order | |
| Function not supported | |
| New response chains not allowed | |
| FI bit not allowed for function management (FM) data | |
| Sequence number error | |
| Chaining error | |
| Bracket error | |
| Data traffic reset | |
| Direction error | |
| Request not executable | |
| Change direction (CD) required | |
| Activate LU (ACTLU) type not COLD or error recovery procedure (ERP) -internal error | |
| Unsupported code point received | |
| Extended data stream function not supported | |
| Read state error | |
| The device does not support extended data stream | |
| WCC had "Start Print" but not last structured field | |
| Negative response received | |
| An internal error occurred; see the error log file for details | |
|
|
|
 |
|