|
|
|
|
Program Check codes indicate protocol or data stream errors detected by either the node or the 3270 emulation program. They appear on the 3270 status line as
PROGnnnmessages, where
nnnis defined as follows:
| Number | Description |
Invalid command received or invalid alias for SFE, MF, or SA | |
Out of range address for SEA, RA, or EUA order MF order addressed non-field attribute location |
|
Data stream data after Rd, Rd Mod, EAU command Invalid parameter following SFE, MF, SA, GE, or RA order | |
| Data stream terminated before end of order | |
| Function not supported | |
| Exception response chain received when BIND specified definite response | |
| Definite response chain received after BIND specified exception response | |
| New response chains not allowed | |
| FI bit not allowed for function management (FM) data | |
| Sequence number error | |
| Chaining error | |
| Bracket error | |
| Data traffic reset | |
| Direction error | |
| Request not executable | |
| Change direction (CD) required | |
| Activate LU (ACTLU) type not COLD or error recovery procedure (ERP) | |
| Profile error on BIND | |
| Primary protocol error on BIND | |
| Secondary protocol error on BIND | |
| Common protocol error on BIND | |
| Screen size error on BIND | |
| LU profile error on BIND | |
| Negotiable BIND rejected (sense code 0821 sent) | |
| Unsupported code point received | |
| Extended data stream function not supported | |
| Read state error | |
| The device does not support extended data stream | |
| WCC had "Start Print" but not last structured field | |
| Connection between local node and 3270 link service has failed | |
| Negative response received | |
| An internal error occurred; see the error log file for details | |
|
|
|
 |
|